Get matched with top boiler installation pros in Gray, ME

A furnace is a big unit where gas, heating oil, or electricity heats the air. The warmed air is then pushed back out through ducts and vents. 

A boiler uses electricity, heating oil, or gas to heat water that is pushed into the room through a radiator. This is one of the oldest and most effective ways to heat a house, but radiators can also be unsightly and leave hot and cold spots in the room.

Heat pumps use a refrigerant to move heat from outside into the house and return it to the room through ducts and vents.

The best time to buy home heating oil is in the summer when the demand is lowest, as the prices are usually lower. However, waiting until the summer to buy is often unavoidable unless you install a separate storage tank. If you have the space for a second tank, you can expect to pay between $1,000 and $4,000 for the oil tank replacement or installation, depending on the capacity and location. You could quickly recuperate these costs, though, by stocking up on heating oil in the summer and avoiding deliveries in the winter when prices are highest.

No, boilers and water heaters are not interchangeable because they serve different primary functions. Boilers are used for central heating systems, providing hot water or steam to heat your home. In contrast, a water heater's purpose is to supply hot water for daily household use, such as for faucets and showers. A water heater alone cannot supply the warm water or steam needed for a central heating system.

While they are not interchangeable, it is common to have both a boiler and a water heater. In fact, a conventional boiler often works best when a water heater system is already in place. The two systems can be combined to provide both heating and hot water, either by pairing a boiler with an indirect water heater or by installing a premade combination boiler-water heater unit. For home heating, some homeowners may also opt for a furnace instead of a boiler.

An expansion tank must always be installed on the supply side, which is the side where the boiler sends water out to heat the systems. That placement allows the water to push against the air and condense properly as it is heated, then circulated through the system. Professional installers can recommend the best place on the supply side for an expansion tank.