Get matched with top well and pump technicians in Cushing, ME

Here are some signs of a bad well pump that a pro should look at: 

• If your well pump isn’t pumping water, you could have a leak or malfunctioning pump on your hands. 

• If your water pump runs nonstop, there might be a leak or problem with the pressure tank, which can cause the pump to fail. 

• Low water pressure can happen because of your pressure tank, low-water levels, or a wrong-sized pump. 

• Dirt or sediment in your water can be a problem with a powerful pump, damaged pump filter, or the pump’s location.

The cost to replace a well-pump motor will depend on the size, but this repair is often as costly as installing a new pump. Generally, a well-pump replacement will cost between $950 and $2,650, with an average of $1,800. Other factors like pump type and pipework will impact your final cost.

The precharged pressure tank should start at around 28 psi. The two pressure settings of note are the cut-in and cut-out pressure. The well pump starts when the tank reaches the minimum cut-in pressure. It turns off when the tank reaches the maximum cut-out pressure. The desired water pressure in the household is usually a few psi above the cut-in number. The difference between the cut-in and cut-out pressure settings should be 20 psi. Typical settings for household applications include 20/40, 30/50, and 40/60.

If your water pump fails, the first step is to turn off the power to the pump to prevent any further damage. Check for common issues such as clogs, electrical problems, or mechanical failures. If you cannot identify the problem, contact a professional who specializes in pump repairs. Prompt action can help minimize damage and repair costs.