Top-rated drywall pros.

Get matched with top drywall pros in Bradley, ME

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Bradley, ME?

Select your specific project to find the pro for you.

Find Drywall pros in Bradley

Sean Gleason Home Improvements
5.0(
45
)
Drywall - Repair

Serving Bradley, ME and surrounding areas

Approved

In business since 1990

Free estimates

Credit card accepted

"Sean has done a project at 2 different homes that we own. He is honest, responsible and communicates throughout the project. He built a handicap ramp at one house when we needed it quickly. He replaced cedar shingles and replaced roof shingles at our coastal seasonal home. Both projects were completed timely and exceeded my expectations. I highly recommend him."
Response time1 day
Recommended by87%of homeowners
Heath Enterprises
4.1(
40
)
Drywall - Install

Serving Bradley, ME and surrounding areas

Approved

In business since 1997

Free estimates

Emergency services offered

"Dave showed up when he said, completed all of the work as promised and even better than promised. The crew was professional, and always thorough. I hired him again after the first job for another roof repair, and my son will be hiring him after seeing the work he did. This is the company to go to."
Hard wood flooring begins
Hardwood flooring instaled
Hardwood flooring
Sub floor repairs
Subflooring repaired

+6

Response time2 days
Response rate86%
9 neighbors recently requested a quote
Avatar for DP Painting
DP Painting
5.0(
4
)
Drywall - RepairDrywall - Repair - For Business

Serving Bradley, ME and surrounding areas

Approved

Super Service Award Winner

In business since 2024

Free estimates

Small jobs welcome

"David figured out a challenging project on a cabinet so old that its hinges are no longer available. He was courteous, professional and punctual. I am grateful that his creative thinking and stick-to-itiveness resulted in a cabinet door that is working again! Thank you, David!!!"
Interior
Interior
Entryway
Entry
Jobs

+12

Response time6 hrs
Response rate87%
29 neighbors recently requested a quote
...
Showing 1-10 of 81
Drywall questions, answered by experts

If your premixed drywall mud is dried out or has begun to set in the bucket, you may be able to revive it by adding warm water and stirring. However, the first and most important step is to scrape off any hard, dried bits of drywall that may have accumulated toward the top of the container and throw them away because they will not easily reconstitute back into the drywall mud mix.

The two most common drywall thicknesses for ceilings are 1/2-inch and 5/8-inch. For most standard residential applications, 1/2-inch drywall is sufficient and widely used. It provides adequate support and is lighter and easier to handle during installation compared to thicker sheets. However, 5/8-inch drywall is often used for specific cases where additional benefits are needed. It is heavier but provides superior sound dampening and fire resistance. You should consider using 5/8-inch drywall for ceilings in commercial buildings, between a garage and a living space, or above a finished basement to meet building codes or for enhanced soundproofing.

To hide drywall edges, you need to properly apply drywall tape and multiple layers of joint compound. These materials hide the seams between drywall sheets and fill the holes from drywall screws, leaving behind a smooth, flat finish to paint over. Apply joint compound smoothly, and finish the job by sanding the walls to make sure you fully hide drywall edges and other imperfections.

Yes, you can apply new plaster over an existing plaster surface, such as a wall or ceiling, provided the old plaster is in good condition. Before you begin, check the stability of the existing plaster. The surface must be clean, free of loose material, and have no peeling paint. It is also recommended to roughen the surface slightly to promote adhesion. For older plaster, applying a base coat like a PVA emulsion or a specific bonding agent or primer is crucial. This step makes the existing plaster less porous and ensures the new and old layers adhere properly for a smooth, long-lasting finish.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

The Bradley, ME homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.