Get matched with top pool table assembly pros in Warwick, MD

Installing an infinity pool takes up to 12 weeks. It can take as long as 20 weeks if you have a complex design, are building a pool in an inaccessible area, or face weather-related construction delays. Either way, this is a big job that requires a lot of time and labor to get it right. Pool construction is not a job that should be rushed, as poor installation can lead to expensive recurring repair costs. 

If you use a pool heater, your pool will lose more water. A pool heater warms up the water, causing it to evaporate faster than it normally would. Installing a pool cover and keeping your pool covered when it’s not in use is one way to limit the amount of water lost through evaporation.

Water only runs through a pool heater when not in use if the heater doesn’t have a bypass system. A bypass system stops the flow of water through the heater when not in use. If you don’t have one, then yes, water will still run through the pool heater even when not in use. Not having a bypass system may increase the effects of wear and tear on your pool heater or disrupt the water’s chemical balance.

It’s fair to be concerned about handling pool lights or wiring in a pool filled with water. But fortunately, pool lights and swimming pools are designed to make it easy and safe to replace the lights without needing to drain the water. Instead, you can turn off the electricity to the pool as a safety precaution, unscrew the pool fixture, pull it up and out to the side of the pool, then change the bulb.