"Furnace was not operating because the company's automatic delivery system ran me out of oil. Technician showed up promptly and got the furnace operating but could not get heat into the house. Had to reschedule to have zone valves replaced. Technician show up late and didn't have the required parts. Had to reschedule again. The third technician showed up on time with all the correct parts and worked most of the day to get the system operating properly. He was completely knowledgeable and very conciencious that everything was working correctly.
"JDL replaced a defective propane furnace and did an excellent job. The new one is installed better than the original. JDL scheduled an inspection by the county inspector also said they did an excellent job. They were efficient, timely and friendly."
"I had a leak somewhere in my heat pump system from 2013 in a 4 floor condo building. Every other company was quoting me $7k+ to replace the system but it turns out to be a leak in the line set between the 3rd floor and the roof! We had a new line set installed and I spent $2550 in total! The crew was very professional and worked extremely had in the hottest weather to get the job done, too!"
Whether you need a repair, preventive maintenance, or replacement, we are your plumbing, heating, and air conditioning service provider in the northern Virginia and surrounding areas. We invite you to give us a call!
"We hired Sucoy Company to install a heat pump in a new ADU. Although the work is still in progress, Justin was very easy to communicate with and very helpful in providing information. We subsequently hired them to change the thermostats in our main house, and John did a great job. He was friendly, easy to communicate with, and on time. The first time he came out, it turned out that one of the new thermostats was defective, and he did a good job troubleshooting to pinpoint the problem, and then came back another day to install a new thermostat."
"Mike, the owner, arrived on time took out the entire old system and installed the complete new system. The installation appears to be very well done. Area was left nicely cleaned up. According to my research the system units (Furnace, A/C, condensate pump, thermostat, filter etc.) that Mike recommended and installed were a good balance between cost and efficiency. I would trust his recommendations unhesitatingly. He did a fine job!"
"Our service technician was David. He arrived earlier than expected and went straight to work. Our new pump was installed in less than one hour. We were pleased with the work. He came after hours 6:30pm and did not charge an exorbitant fee. He was pleasant and very informative when asked questions. If there was a topic he was not familiar with he answer "I'm not sure". I like reliable companies with professional employees. We had another plumber come earlier and wanted to charge us $452 dollars for a 1/2 HP pump that cost on average $242, $200 for accessories for installation (I paid $276 taxes included for pump and accessories), labor charge to go and pick up the pump and to install the pump. His price $1252. I was told that it was considered an emergency so that is why the price was so high. This was the morning two days after the flood. After we got the pump we called several times and no response as of yet, He's off my list completely. I share this illustration so that buyers can make educated decisions about how best to spend their money. I don't assume that the plumber whose charges were 50% higher than anyone else I called on Angies List. I simply say do your homework and know what is considered a fair price. Thank you Jerry's Heating and Plumbing. You do excellent work in a timely fashion!"
"The entire experience from scheduling an appointment for the plumber as well as the work itself (installing a new sump pump) went exceptionally well. Sergio the plumber was meticulous in his preparations to ensure a successful outcome and he was more than willing to share information about the work he was performing. He exhibited remarkable professionalism for his craft and a very approachable demeanor. We would enthusiastically and without hesitation ask for him in the future. As for the initial contact with the company and the scheduling of the appointment, Pete Kristiansen, was not only helpful but also accurate in his predictions of a time line for the work being accomplished. Kudos to Jiffy Plumbing & Heating, Inc. for an excellent job from start to finish !"
On average, you’ll need about two gallons of oil per day to heat your house when it’s 50 degrees Fahrenheit outside. Most oil tank capacity is about 275 gallons, and heating your house with two gallons of oil per day will last about four and a half months. This consumption will vary depending on the climate and average temperature in your location. For example, if the winters are longer and colder where you live, you’ll probably need to refill your oil tank at least once to get through the winter.
Generally, an oil furnace is considered safer than a gas furnace for several reasons. While both types of furnaces can produce carbon monoxide, a leak in an oil furnace is easier to detect due to the smell. Oil furnaces also don't connect to a gas pipeline, which reduces the chance of a fuel leak. Most importantly, heating oil is not combustible, whereas natural gas is highly flammable. This means there is a much lower risk of combustion or explosion with an oil furnace. However, an oil furnace can still pose a fire hazard if it tips over.
Yes. Boilers need water to run without overheating, also known as dry firing. If you run it without a sufficient volume of water, either because of a burst pipe or a leak, you run the risk of damaging your machine or jeopardizing the safety of your home as a whole. When in doubt, shut off your boiler and repair any plumbing issues before turning it back on. Alternatively, consider installing a low-water cutoff (LWCO) before any issues arise. This gadget will protect your boiler by monitoring water levels and automatically shutting it off if it gets too low.
The cost-efficiency of baseboard heaters depends on the type and how you use them. Generally, standard electric baseboard heaters can be expensive to run because they use electric resistance heating, which is less energy-efficient than systems like forced-air or heat pumps. However, hydronic and gas versions are typically much cheaper to operate. Hydronic models are more energy-efficient because they heat a liquid that retains warmth longer, preventing the thermostat from turning on and off as often. The overall running cost is also influenced by local electricity rates, your home's insulation, and your usage habits. To increase efficiency, you can use baseboard heaters for zoning, meaning you only heat the specific rooms you are using.
In most cases, repairing a radiator is more affordable than replacing it. A typical repair may cost between $100 and $200, while a replacement can average $1,500, with a range of $250 to $2,500 depending on the unit type. Radiator issues are often simple fixes for a professional, such as a blown fuse, malfunctioning thermostat, or a loose valve, and can take less than an hour. However, if the long-term costs of fixing the radiator are higher than replacement, it's better to get a new model. It is recommended to consult a heating expert to diagnose the problem and determine the best solution for your situation.
The Marlow Heights, MD homeowners’ guide to boiler installation services
From average costs to expert advice, get all the answers you need to get your job done.
The average boiler installation cost depends on size, system type, and other factors. Keep reading to learn the cost of a new boiler in Washington, D.C.
Find out the average radiator and boiler repair cost in Washington, D.C. Learn what you can expect to pay for local heating services and keep your home warm.
