Top-rated insulation pros.

Get matched with top insulation pros in Ijamsville, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your insulation service project in Ijamsville, MD?

Select your specific project to find the pro for you.

TRUSTED BY IJAMSVILLE, MD HOMEOWNERS

  • Average homeowner rating star icon4
    Average homeowner rating
  • Verified reviews icon113
    Verified insulation services reviews

Find Insulation pros in Ijamsville

Avatar for RetroFoam of Philadelphia
RetroFoam of Philadelphia
5.0(
22
)
Spray Foam Insulation - InstallInjection Insulation - Install

Serving Ijamsville, MD and surrounding areas

Approved (Corporate)

In business since 2023

Free estimates

Warranties offered

"We are extremely satisfied with the whole process of our house being insulated. First we had the walls done, and then a couple weeks later we had our attic insulated. The crew were so nice, friendly, and knowledgeable. We are very satisfied with everything. Thank you, everyone."
RetroFoam Wall Insulation
Installing RetroFoam
RetroFoam with Siding
RetroFoam with Brick
Response time1 day
Response rate100%
113 neighbors recently requested a quote
Avatar for Tri-State Builders
Tri-State Builders
4.6(
104
)
Spray Foam Insulation - InstallInjection Insulation - Install

Serving Ijamsville, MD and surrounding areas

Approved

In business since 2000

Free estimates

Emergency services offered

"On time, courteous, clean and efficient. Foamed and drywalled the garage efficiently, and cleaned up well after the job. Provided advise on issues seen during insulation preparation. Great service."
 Kitchen
Barber Addition
Rowland Addition
Custom Home
Traska Addition

+36

Response time3 days
16 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.1(
34
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeSpray Foam Insulation - Install

Serving Ijamsville, MD and surrounding areas

Approved

In business since 2009

Free estimates

Credit card accepted

"I hired Atlas Home Energy Solutions to remove old insulation and replace it with the foam technique. However, I ran into numerous unexpected problems due to a slow leak from old pipes. It took awhile to sort out. Atlas Home Energy Solutions gave me lots of expert advice. They were willing to come out and review the situation. They were also willing to reschedule and wait until another contractor dealt with the water issue and its ensuing problems. They helped me make some difficult decisions before they could insulate the crawl space. When it was ready for them to come and insulate the area they bumped their schedule forward to get it done. This company did sterling work. Their expertise and professionalism were outstanding. They really know what they are doing and guided me through a more protracted process than originally envisioned. I would highly recommend them to anyone."
Visual Inspection of all Areas of your Home
Attic Insulation and Air Sealing
Infrared Camera Inspection
Attic Spray Foam
Blower Door Whole House Air Leakage Test

+11

Response time1 day
Recommended by87%of homeowners
Avatar for Atlas Home Energy Solutions LLC
Atlas Home Energy Solutions LLC
4.9(
106
)
Blown-In Insulation - Install or UpgradeBatt, Rolled or Reflective Insulation - Install or UpgradeInsulation - Install or Upgrade+1 more

Serving Ijamsville, MD and surrounding areas

In business since 2009

Free estimates

Warranties offered

"I contacted Atlas not because of high energy bills but because of noticeable summertime temperature differences between the first and second floors. My home is 32 years old and had never had the ducts cleaned and I suspected there was leakage from seams in the duct work. While the house was built to the then current (1988) code levels, the code is now more stringent. For example, my attic insulation was R30 where code is now R50. Atlas first performed an energy audit. Based upon that outcome, they recommended: (1) rerouting the bathroom exhaust fans through the roof, (2) additional insulation in the attic bringing it to R50. (3) closed cell foam sealing in the main and garage attics where appropriate, (4) cleaning the heating/cooling ducts and (5) using the AeroSeal product in the same ducts. I opted for all of these services. The work was spread over 3 occasions, each no more than 2 days duration with most completed in a single day. Their friendly work crews were very attentive to my property, made sure to put down drop cloths throughout the house and generally made certain everything was clean upon leaving. They kept me informed throughout every task and showed/explained what they had encountered. My ducts certainly did need cleaning, even though it’s always been a smoke free home environment and without pets. The benefits of this work have been fantastic. The AeroSeal process yielded a 98% reduction in duct leakage. I can tell very little temperature difference between the first and second floors now. I’m expecting more noticeable improvements during the winter months. I strongly without reservation recommend Atlas Home Energy Solutions."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+16

Response time3 days
Response rate100%
1 neighbors recently requested a quote
Cameron Home Insulation
4.6(
40
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Ijamsville, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
METRO INSULATION, LLC.
2.9(
98
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Ijamsville, MD and surrounding areas

In business since 2004

Credit card accepted

"
Company personnel scheduled to do the work on a semi holiday and they arrived on time/when they said they woudl.  They were very attentive to doing a good job - they lined the floor with plastic; they vacuumed up excess insulation).  They even phoned up days after completing the project to inform us that we might be able to take advantage of a tax benefit.  We would definitely recommend this company."
Recommended by87%of homeowners
...
Showing 1-10 of 71
Insulation questions, answered by experts

The life span of insulation is between 20 and 100 years. At that time, existing insulation can fall victim to gravity, resulting in compression, which reduces its insulating protection or R-value. If you can't simply add more insulation over the existing material, removing the old to increase the effectiveness of the new can reduce your energy bills and make the project worth the time and money investment.

Insulation can be easy to install, depending on the condition of your walls, but there are many safety considerations and potential challenges involved. For example, most types of insulation are made from materials that can cause irritation if inhaled or if they come into contact with your skin. Additionally, installing insulation incorrectly can actually make moisture issues in your home worse.

Winterizing your outdoor plumbing keeps your outdoor spigot from freezing and potentially bursting. This includes draining residual water out of the pipe and spigot after turning the valve off, then removing garden hoses and other attachments from the spigot before winter comes. Insulating the pipe that leads to the spigot and installing a freeze-proof faucet also help, as does installing an outdoor faucet protector.

If you’re moving wires, installing new wires, or installing new fixtures in the space you’re insulating, then you will need to hire a licensed electrician to do that portion of the job for you. However, if you just intend on replacing old insulation or adding new insulation over existing insulation, then you don’t need to hire one. Your insulation installer will work around wiring, fixtures, outlets, and switches, even if they’re installing fiberglass batts in the voids where wires run. However, you will need an electrician if you suspect a problem with your wiring during the insulation work.

It's essential to use insulation materials specifically designed for air ducts. Common types of duct insulation materials include fiberglass, foam board, and reflective foil. These insulation materials have the right properties to withstand the temperature and airflow conditions within the ductwork. Using the appropriate insulation not only ensures efficient temperature control but also prevents potential safety hazards or the release of harmful particles into the air.

The Ijamsville, MD homeowners’ guide to insulation services

From average costs to expert advice, get all the answers you need to get your job done.