Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Forest Hill, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Forest Hill, MD?

Select your specific project to find the pro for you.

TRUSTED BY FOREST HILL, MD HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon319
    Verified drywall insulation services reviews

Find Drywall insulation pros in Forest Hill

Avatar for Koala Insulation of The Greater Baltimore Area
Koala Insulation of The Greater Baltimore Area
4.8(
13
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Forest Hill, MD and surrounding areas

Approved

In business since 2023

Free estimates

Warranties offered

"We had insulation installed a week earlier by Koala. During the insulation, Jasper (insulator) suggested another area that we might consider installing blown-in insulation. We agreed and the second job was performed on Friday, the 24th. Jasper and Richard were on time, the insulation project was well done and they left the area very clean. Would use them again."
Insulation Projects
Spray Foam Insulation
Insulation Projects
Blow-in Rig
Truck

+9

Response time8 hrs
1 neighbors recently requested a quote
Recommended by83%of homeowners
Avatar for RetroFoam of Philadelphia
RetroFoam of Philadelphia
5.0(
22
)
Injection Insulation - Install

Serving Forest Hill, MD and surrounding areas

Approved (Corporate)

In business since 2023

Free estimates

Warranties offered

"We are extremely satisfied with the whole process of our house being insulated. First we had the walls done, and then a couple weeks later we had our attic insulated. The crew were so nice, friendly, and knowledgeable. We are very satisfied with everything. Thank you, everyone."
RetroFoam Wall Insulation
Installing RetroFoam
RetroFoam with Siding
RetroFoam with Brick
Response time1 day
Response rate100%
123 neighbors recently requested a quote
Avatar for Mister Insulation LLC
Mister Insulation LLC
5.0(
8
)
Blown-In Insulation - Install or Upgrade

Serving Forest Hill, MD and surrounding areas

Approved

Super Service Award Winner

In business since 2000

Free estimates

Emergency services offered

"We called Mister Insulation and Jeff came out in a day or so. We explained that we purchased new windows and doors and had insulation blowen into the walls but the house was still not warm. He took pictures in the attic and used a thermal camera to show where we were losing heat also we had mold. He removed the mold and replaced the insulation . He and his crew were very professional. We would recommend them ."
Energy Evaluation
EnergyStar Seal
Building Code
NASA Tech!
Solar Venitilation

+1

Response time8 hrs
Response rate94%
5 neighbors recently requested a quote
Avatar for ROI Construction LLC
ROI Construction LLC
4.1(
18
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Forest Hill, MD and surrounding areas

Approved

In business since 1974

Free estimates

Warranties offered

"We had a great experience with ROI Construction sales representative David Burke. David was very knowledgeable about ROI's porducts and services. We look forward to getting our attic insulation project completed and will provide a more thorough review at that time. Thanks, Tim"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+19

55 neighbors recently requested a quote
Recommended by90%of homeowners
Cameron Home Insulation
4.6(
40
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Forest Hill, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.7(
14
)
Blown-In Insulation - Install or UpgradeInsulation - Install or Upgrade

Serving Forest Hill, MD and surrounding areas

In business since 2009

Free estimates

Warranties offered

"5 stars!! Their pricing was the most competitive, and their communication was outstanding! Had our THOW insulated with closed cell spray foam and they did an awesome job from the very beginning of the process until the end. Would highly recommend!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+16

Response time3 days
Response rate100%
Recommended by91%of homeowners
Avatar for Home Energy Loss Professionals (HELP)
Home Energy Loss Professionals (HELP)
4.4(
73
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Forest Hill, MD and surrounding areas

In business since 2004

Free estimates

Emergency services offered

"Bob the owner helped me through the whole process from having the audit done on my home and did the insulation work as well. His crew was also polite and hard working, they got the job done when they said they would and I’m so pleased with the results ! My home is the same temperature on every level and my energy bill is lower then it’s ever been. Thank you Bob and your team I will definitely be referring you to my friends and family."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by87%of homeowners
Showing 1-10 of 45
Drywall Insulation questions, answered by experts

Drywall insulation costs around $1,800, on average, but prices can range from $500 to $4,500, depending on a few different factors. The following things are important considerations to make when pricing out your insulation project:

  • Square footage of insulation

  • Type of insulation 

  • Climate in your area and the insulation R-value required

  • Whether or not your walls are already finished

  • Accessibility of the area 

  • Whether or not you need old insulation removed first

You should stagger drywall sheets to help prevent cracking. The joints between drywall sheets are the weak spots, so if you install drywall with seams aligned, you’ll create weak lines that run across the length of the wall and extend from floor to ceiling. But when you stagger drywall, the solid sections of panels will support the joints. This can prevent seams from cracking or separating due to fluctuating temperature and humidity, vibrations from movement inside the home, and gravity.

Whether Venetian plaster increases your home's value often depends on the buyer's preference. As a purely aesthetic upgrade, it doesn't add structural value in the same way a kitchen or bathroom remodel might. However, its beautiful and attractive appearance can make a home more appealing to potential buyers, possibly leading to more interest, higher offers, and increased competition when you sell.

If your home was built before the 1940s and was not remodeled in the past 50 or so years, you probably have plaster walls. Aside from assuming, there are some practical ways to tell if you have plaster walls, including the following: If you knock on the wall and it feels solid, not hollow, if you can’t insert a thumbtack easily, if there are cracks that look like spiderwebs, or if your home has curved, arched, or swirled walls, doorways, or window openings.

If you have an unfinished basement or attic, you could examine the backs of any finished walls to check, too.

To hide drywall edges, you need to properly apply drywall tape and multiple layers of joint compound. These materials hide the seams between drywall sheets and fill the holes from drywall screws, leaving behind a smooth, flat finish to paint over. Apply joint compound smoothly, and finish the job by sanding the walls to make sure you fully hide drywall edges and other imperfections.

The Forest Hill, MD homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.