Top-rated paving pros.

Get matched with top paving pros in Parsons, KS

Enter your zip and get matched with up to 5 pros

Need a pro for your paving service project in Parsons, KS?

Select your specific project to find the pro for you.

Find Paving pros in Parsons

Avatar for Tri-State Sealing and Striping
Tri-State Sealing and Striping
New to Angi
Asphalt Paving - Repair or PatchAsphalt Paving - Repair or Patch - For Business

Serving Parsons, KS and surrounding areas

Approved

In business since 2022

Free estimates

Credit card accepted

Asphalt paving, asphalt sealcoating and Repair, Asphalt Parching, pavement sealing, Chip and seal, Crack Repair, Line Striping, driveways, Parking Lots, Roads, New installs, repairs, overlays, digout and haul off for commercial residential, municipal, serving Missouri, Kansas, and Oklahoma, Free Estimates,

Crack repair
Asphalt sealing
Response time1 day
4 neighbors recently requested a quote
Avatar for Neely's Masonry
Neely's Masonry
4.3(
3
)
Interlocking Pavers for Patios, Walks & Steps - Install

Serving Parsons, KS and surrounding areas

"Removed old blocks and hallway the old blocks. Services was very good. Did great putting in the new blocks. If i want more masonry done. I will get a hold of Neely Masonry again."
Masonry Project
Masonry Project
Mailbox
Masonry Project
Masonry Project

+14

Recommended by100%of homeowners
Showing 1-10 of 18
Paving Services questions, answered by experts

Compared to a 10x20 concrete driveway costing between $800 and $3,000, a resin bound driveway of the same size costing $3,900 to $4,000 is the more expensive option. However, the cost still makes resin a cheaper option compared to a 10x20 paver driveway costing an average of $12,000.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

Heated driveways cost an average of $12 to $25 per square foot. Depending on the size of your driveway, you may pay between $3,500 to $25,000 in total. Several factors can affect your bottom line, including material, labor, and system types. Investing in a heated driveway can save on snow removal costs because it will automatically melt the snow that falls on your driveway.

The stones do not work well on uneven ground. If the stones are not buried into the ground and made level upon installation, they almost certainly will shift or crack on uneven ground. Additionally, rainwater or water from sprinklers can run under the edge of an uneven paver, causing erosion. In a freeze and thaw cycle, trapped water under the paver can cause the problem to worsen by shifting the stepping stones around. Use a bubble level to make sure the ground under each paver is as even as possible, even if the nearby ground is uneven.

The material that’s best for your private road depends on your property, the climate in your area, and your personal preferences. Gravel is an affordable option, but some homeowners don’t like how it looks. It can be a pain to remove snow from, and it requires more ongoing maintenance than asphalt or concrete. However, while these other options require less maintenance and make snow removal a breeze, they’re more expensive and will need repairs from time to time. Ultimately, you’ll have to choose the road material that suits you and your property best.

The Parsons, KS homeowners’ guide to paving services

From average costs to expert advice, get all the answers you need to get your job done.