Best roofers near New Castle, IN

You cannot replace granules that have been lost off shingles. The granule embedding process is part of shingle manufacturing, and once the bond holding the granules to the shingles has been lost, the granules are gone for good. Shingles with granule loss must be fully replaced to continue offering adequate protection.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Metal roofs do not inherently leak more than shingle roofs; when properly installed, they are generally less likely to leak. Asphalt shingle roofs are more susceptible to leaks due to factors like wind uplift, damage from extreme weather, moss growth, and ice dams. Over time, asphalt shingles also lose their protective grit, which reduces their waterproofing capabilities. In contrast, metal is a more resilient material that stands up better to heavy precipitation and high winds. However, metal roofs can develop leaks if they are poorly installed, have improperly sealed fasteners, or experience issues from thermal expansion. For this reason, professional installation and regular maintenance are crucial to ensure a metal roof's longevity and superior protection against leaks.

Condensation can occur on the inside of a roof, but it should always be temporary. It does not necessarily mean there is a roof leak. Condensation happens when the inside and outside of a house are at different temperatures. For instance, if it is hot during the day and then gets very cold at night, the inside of the house will be warmer than the outside and may cause condensation to form on the inside of the attic. This may not be cause for concern, but if it is happening frequently, it should be addressed; otherwise, it could cause roof leaks, compromise the structural integrity of the wood, or allow mold to grow.