Get matched with top drywall pros in Monroe City, IN

To hide drywall edges, you need to properly apply drywall tape and multiple layers of joint compound. These materials hide the seams between drywall sheets and fill the holes from drywall screws, leaving behind a smooth, flat finish to paint over. Apply joint compound smoothly, and finish the job by sanding the walls to make sure you fully hide drywall edges and other imperfections.

You should always work from top to bottom when hanging drywall. There are a few reasons for this. For one, starting at the top makes it easier to create a straight wall between the ceiling and the wall. Plus, moving downward lets you avoid any awkward gaps at the top. It’s easier to deal with gaps at the bottom because you can cut the drywall to fit the space or cover the gap with baseboard trim.

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.

You can prevent air leaks and sagging by gluing a drywall ceiling. However, not every drywall job is a good fit for Sheetrock adhesive, and many pros say ceilings are one of those cases. When you place them properly, drywall screws make ceiling Sheetrock part of your home’s structural support system. 

Adding glue won’t increase the strength of the drywall, and it can make it much harder for you to remove and replace damaged drywall. Adhesive can bridge gaps, though, and it can keep temperature-controlled air from escaping or entering through the ceilings, making rooms more energy efficient.