Get matched with top well and pump technicians in Orangeville, IL

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

The precharged pressure tank should start at around 28 psi. The two pressure settings of note are the cut-in and cut-out pressure. The well pump starts when the tank reaches the minimum cut-in pressure. It turns off when the tank reaches the maximum cut-out pressure. The desired water pressure in the household is usually a few psi above the cut-in number. The difference between the cut-in and cut-out pressure settings should be 20 psi. Typical settings for household applications include 20/40, 30/50, and 40/60.

If your water pump fails, the first step is to turn off the power to the pump to prevent any further damage. Check for common issues such as clogs, electrical problems, or mechanical failures. If you cannot identify the problem, contact a professional who specializes in pump repairs. Prompt action can help minimize damage and repair costs.

Both can deliver clean water to your taps, but well water and city water carry a few differences. City water is delivered and connected through a main water line, and it travels through a network of underground private and public pipes to service various buildings and structures once it’s been treated.

Well water is derived from dug or drilled wells that source groundwater from the water table. City water is often more expensive than well water, but it eliminates the need for you to test and treat your own well water.