Top-rated garbage removal pros.

Best garbage removal pros near Emmett, ID

Enter your zip and get matched with up to 5 pros

Need a pro for your garbage removal project in Emmett, ID?

Select your specific project to find the pro for you.

TRUSTED BY EMMETT, ID HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon39
    Verified garbage removal services reviews

Top-Rated Garbage removal pros in Emmett - Updated Nov 2026

Avatar for Junk King Boise
Junk King Boise
4.3(
66
)
Garbage Pickup and Waste Management

Serving Emmett, ID and surrounding areas

In business since 2017

Free estimates

Credit card accepted

"They were hired to remove a broken recliner from my home. They were polite, efficient and got the job done. I would definitely hire them again and highly recommend them. The price was reasonable."
Hoarder house in Homedale
Hoarder house in Homedale
Garage
Living room
Shovels not brooms

+9

Response time7 hrs
Recommended by96%of homeowners
Showing 1-10 of 34
Garbage Removal FAQs, answered by experts

These appliances do unscrew, but you need to disconnect everything properly when you replace your garbage disposal. Make sure you shut the power off to the area first and check that it’s off with a voltage detector. Disconnect the main drain line and P-trap, and then disconnect the dishwasher drain line if you have one connected. You can then unscrew your garbage disposal using a disposal wrench. Just make sure you disconnect the electrical lines before removing your appliance.

Most garbage disposals have a reset button that can be triggered with a tool as simple and accessible as your index finger. That said, if you need to perform a more in-depth troubleshooting step, like manually moving the arms inside the unit or rotating the impeller plate, a hex wrench is the most common tool you’ll need. Most garbage disposals come with a hex wrench.

No, you do not need a garbage disposal to have a dishwasher. A dishwasher will work without one, and while it's rare to see a home with a dishwasher that doesn't have a disposal, it is possible. The two appliances pair well and are often installed together because a disposal simplifies meal cleanup.

However, your dishwasher should not be used as a replacement for a garbage disposal. Subjecting it to continuous food leftovers can lead to major clogs. If you choose not to install a garbage disposal, you should thoroughly rinse your plates or scrape excess food into the trash or a compost pile before loading them into the dishwasher to prevent plumbing issues.

While unplugging your garbage disposal and plugging it back in may help, most units have an actual reset button, a bright red switch found on the underside of your unit. If your garbage disposal needs resetting, you may notice this button sticking out about a quarter of an inch from the surface of the unit, with which it’s usually flush. Simply depress this reset button to reset the unit, and then test to ensure it’s working about 10 minutes later.

Replacing a garbage disposal costs anywhere from $150 to $950, but the average cost is somewhere around $550. There are two types of garbage disposal units, and continuous feed disposals tend to cost more than batch feed disposals. Going for an aluminum garbage disposal is also significantly cheaper than choosing a stainless steel garbage disposal. You'll also need to factor in the horsepower of the motor, labor, and the removal and disposal of your old unit.

The Emmett, ID homeowners’ guide to garbage removal services

From average costs to expert advice, get all the answers you need to get your job done.