Best flooring contractors near Waterloo, IA

To clean a subfloor after removing carpet, start by removing any leftover debris, such as stuck-on underlay, nails, or staples. Next, thoroughly vacuum the subfloor to eliminate dust, dirt, and loose particles. If adhesive residue remains, you can use an adhesive remover, a scraper, or a sander to gently lift it off. Finally, clean the surface by mopping or wiping it down with a damp rag and allow it to dry completely. This preparation is essential for ensuring new flooring adheres properly and to prevent bumps or wrinkles from forming.

If you also need to know how to fill the gap between the floor and the baseboard, it's best to use a flexible, paintable latex caulk. Clean the area thoroughly to remove dust and debris. Then, apply a smooth bead of caulk along the gap using a caulking gun, and use a caulk-smoothing tool to press and smooth it into place. If the gap is large, you may need to insert backer rod, such as a foam filler, before caulking. Once dry, paint the caulk to match the baseboard for a clean, seamless look.

Technically, you can start tiling in a corner and work your way out. However, it's not traditionally how tiling is done. Instead, work from the bottom middle of the wall. Tile out the entire row with whole tiles before moving on to the next row. Once you finish installing all of the whole tiles, then you focus on tiling the corners.

Impervious or vitreous tile and vinyl flooring work best for the kitchen. These surfaces are non-porous (or have a very low porosity) that can stand up against spills, splashes, and plumbing leaks. Some natural stones are also a good fit, but keep porosity in mind. You may need to seal them to avoid stains and water damage to the subfloor.