Get matched with top electricians in Urbana, IA

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

How far you can run underground electric depends on the wire gauge (generally AWG) and the circuit voltage. Too much voltage drop in an electrical circuit can negatively affect performance, so the smaller the voltage drop, the better. Ideally, it shouldn't exceed 3%. The smaller the wire and the longer the run, the more significant the voltage drop. 

For example, with a 120-volt circuit, you can run 60 feet of 12 AWG cable without losing more than 3% voltage. With a 240-volt circuit, you can run 120 feet of 12 AWG wire while maintaining a voltage drop of 3% or less.

Like any other household appliance, electric fireplaces can wear out after about 10 to 20 years. With more frequent use, the parts will wear out quicker, and you may get just 7 to 10 years out of a well-loved electric fireplace. Fortunately, electric fireplaces come with a lower upfront installation cost compared to alternatives like gas, so you can install a replacement for less.

A 60W LED bulb is likely labeled as “60W replacement” on the package—that’s because it provides about the same light output as a 60W incandescent bulb. In reality, it likely uses less energy—usually 15 watts or less. If that’s the case, then it’s perfectly fine to put a 60W LED bulb in a 40W socket. Your best bet is to read the package carefully. It will tell you the LED bulb’s actual wattage, and as long as it’s lower than the fixture, the bulb will be safe to use.