Top-rated contractors.

Get matched with top contractors in Keokuk, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Keokuk, IA?

Select your specific project to find the pro for you.

Find Contractors in Keokuk

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Keokuk, IA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Keokuk, IA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Avatar for Preferred Home Improvements
Preferred Home Improvements
4.7(
12
)
Major Home Repairs (General Contractor)

Serving Keokuk, IA and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Dillon was a great guy and worked fast and efficient. My house is 50 plus years old and the duct work had never been cleaned. Post the work, the house even smelled better. I am in the middle of a complete remodel and living in the house. I had all 11 vent grilles removed -(saved Dillon a pile of time not having to remove and re-install) and I would have thought a discount would have been in order."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+30

Recommended by100%of homeowners
Avatar for Kruse Quality Construction & Spray Foam Insulation, LLC - Home  Facebook
Kruse Quality Construction & Spray Foam Insulation, LLC - Home Facebook
New to Angi
Major Home Repairs (General Contractor)

Serving Keokuk, IA and surrounding areas

In business since 1990

Free estimates

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business!

Response time10 mins
Showing 1-10 of 11
Unfinished Carpentry questions, answered by experts

Installing an ornamental or decorative porch column takes around three to five hours. Structural columns take longer because your pro has to install a jack to hold up the roof while switching the column out. If there's any structural damage, it can add several days to the timeline to repair the damage.

Yes, ceiling joists are typically load-bearing. However, their primary function is to support the weight of the ceiling and loads applied to it, like lighting fixtures and ceiling fans. They can also help support the roof, especially if they’re part of truss systems. Remember, the load-bearing capacity of ceiling joists depends on the material, size, and space between them. 

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

In framing, studs are placed at 16-inch intervals to coincide with the typical spacing of wall materials such as drywall or plywood. This spacing is called "on-center" and is necessary for maintaining structural stability and efficient use of materials. The 16-inch spacing also helps to distribute the weight evenly across the building's structure. For those looking to cut material costs and improve energy efficiency, 24-inch stud spacing can be employed through a method called "advanced framing". This requires careful planning and adherence to local building codes to ensure structural integrity.

For maximum stability, install grab bars on wall studs, as this will adequately support the weight. However, if you don't have access to studs, you can get by with wall anchors. If opting for the latter, choose specialty hollow wall anchors. 

The Keokuk, IA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.