Get matched with top affordable plumbers in Dunlap, IA

You should leave the water dripping when temperatures are below 20 degrees for three hours or longer or your power goes out in the winter. Leave the water dripping until temperatures are consistently above 20 degrees and you’ve checked for frozen pipes. With water movement in your pipes, ice is less likely to form, and your pipes are less likely to burst. The drip relieves pressure, preventing burst and leaking pipes.

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

Whether a pot filler is worth it depends on your cooking habits, budget, and kitchen layout. For avid home cooks who frequently prepare pasta, soups, or stocks, the convenience of filling large pots directly on the stove can be a significant benefit. A pot filler can also add value to a home, attracting potential buyers with its combination of luxury and utility. However, the installation can cost around $800. The return on this investment is highest in larger kitchens where the sink is far from the stove. In smaller kitchens, where the sink is nearby, a pot filler might be perceived as an unnecessary feature by some homeowners or potential buyers.

To bleed air from the pipes, start by turning off the main water supply. Then, starting with the faucet that’s closest to the water valve, open each of your faucets halfway, making sure to open both hot and cold options if they’re separate. This allows the air to escape the pipes. Once all faucets are open, turn your water supply back on and let the water run for 10 to 15 minutes until the faucets stop sputtering.