Top-rated asphalt driveway pros.

Get matched with top asphalt driveway pros in Bellevue, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Bellevue, IA?

Select your specific project to find the pro for you.

Find Asphalt driveway pros in Bellevue

All In One
5.0(
4
)
Gravel or Loose Fill Paving - Install, Spread or ScrapeGravel or Loose Fill Paving - Install, Spread or Scrape - For Business

Serving Bellevue, IA and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"My first experience on Angie's List was to find a contractor to repair a leaking roof.  When I purchase my home the roof had been replaced within 2 years of purchasing.  Yet within a year water was leaking into my living room.  When other contractors came out they'd stand in the driveway and look up at the roof, then tell me all I needed were new gutters, which didn't help. All in one actually got up on the roof to investigate determining where my roof was leaking and fix it. With their estimate they provided proof on insurance and state contractor certification.  Before the roof work commenced,  rain was forecast All In One, covered the roof with tarps.  Once the work was completed they cleaned up the yard and driveway of all the old tiles, nails, and other debris.  Shortly after they completed there work, it rained again.  I held my breath but no water came dripping down from the ceiling.  In addition to the roof, since they were going to be up on the roof, I had them replace an old skylight.  No, the skylight wasn't the cause of the leak, I just took advantage of the opportunity to replace it.
"
Recommended by100%of homeowners
Dave Navarro Construction
5.0(
2
)
Concrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install

Serving Bellevue, IA and surrounding areas

In business since 2010

Free estimates

"The workmanship was excellent. The work was completed within the time frame agreed upon as well as the price quoted. Everything was done very professionally from start to finish. I HIGHLY recommend Dave Navarro Construction for any interior remodeling. I will definitely use him again - without hesitation."
Recommended by100%of homeowners
Showing 1-10 of 17
Asphalt Driveways questions, answered by experts

To maintain their strength, asphalt driveways and parking lots need to be sealcoated once every two to five years. You may also need to reapply paint striping every few years as it fades to ensure drivers can safely navigate the parking lot.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

Several materials are suitable for steep driveways. Gravel and crushed stone are affordable options that provide good traction. Permeable pavers—such as plastic, rubber, or concrete—filled with gravel or crushed stones are also excellent, as they allow water to drain without causing erosion and perform well in ice and snow. Another option is resin, which can be coated with an anti-slip finish and helps prevent puddles. For added stability, you can install a retaining wall to prevent pavers and gravel from shifting over time.

Since it has a smoother surface using a mixture of finer rock and sand, 41A tends to be the best asphalt grade for a driveway, especially for residential driveways. Other options are available, but more homeowners choose 41A for a smoother asphalt driveway. Talk with your asphalt driveway professional for recommendations of the best grade for your specific driveway.

Wet cutting is usually the preferred method. It controls dust, which helps protect your lungs and makes for a cleaner working environment. Plus, the water cools the blade, preventing overheating and prolonging its life while providing smoother, more precise cuts. The downside is the mess—water and asphalt sludge can be messy to clean. Dry cutting, though convenient if water isn’t available, creates a lot of dust, which can be harmful. This also increases the risk of blade damage due to overheating. So, if you have the option, wet cutting is the better method for most asphalt jobs.

The Bellevue, IA homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.