Get matched with top fire pit installation pros in Lithonia, GA

The National Fire Protection Association (NFPA) says you can place smoke detectors on either the ceiling or the wall, depending on the setup of your room. Since smoke rises, the ceiling makes sense, but if you go with a wall mounting, the alarm should be installed high up—no less than 12 inches from the ceiling. 

You should not attempt to disable a smoke alarm unless you’ve already activated a replacement unit. To stop a hardwired smoke alarm from beeping, reset the device or silence the alarm. If you’re removing a hardwired alarm, shut off the power, turn the unit counterclockwise to remove it from the ceiling, and disconnect the wiring.

While your forced heating system runs, it can pick up dirt, dust, hair, and other particles from inside your house. Changing your furnace filters regularly is key to preventing this debris from getting stuck in your ducts and swirling around your home. With some types of furnaces, there’s also the potential for carbon monoxide leaks. However, staying up-to-date with your HVAC inspections and installing carbon monoxide sensors can help mitigate this risk.

If a light switch is off, it’s very unlikely to cause a fire. For a fire to start, the switch has to be on, activating an electrical current, and the wiring must be faulty. However, the malfunctioning light switch could cause an intermittent current to move across the electrical wire. This issue could become a fire hazard with another device connected to the wire. You should replace the bad light switch as soon as you notice it or call an electrician.