Get matched with top locksmiths in Portland, CT

Thieves can open almost anything with enough time and the right tools, but they also prefer easy targets that are unlikely to get them caught. Forcing open gates is loud and difficult, and to be able to open one electronically requires extensive knowledge of the system, which most thieves don't have. Electric and other security gates are great deterrents because the thief will move to an easier target. If the thief is determined to enter your property, they will most likely find a different entrance point.

Expect to pay between $50 to $200 if you hire a locksmith to change your locks. That figure includes labor and the cost of basic hardware. The cost will naturally be higher if you plan to install more expensive locks, like smart locks, and if you need a lot of them.

Homeowners can save money by replacing locks themselves. A typical rekeying kit costs about $10 to $25. The only additional cost is purchasing new house keys, and those are no more than a few dollars per key. If you want to replace the locks on your own completely, the main cost is the price of the locks themselves. A standard knob-style lock starts around $25, while electronic locks and smart locks will run in the hundreds of dollars. The only additional tools you should need are a tape measure, screwdriver, and screws if they are not already provided.

It can affect security, especially if you don’t finish it properly. A Dutch door has more moving parts that can be compromised, so you’ll want to use solid hardware and make sure everything lines up and locks cleanly. If the latch is flimsy or the two halves don’t sit tight, it’s going to be easier to force open.

Begin by checking the power source, typically a battery or wired connection. Ensure the battery is installed correctly, has sufficient charge, and isn't corroded. If it's a wired lock, examine the electrical connections to confirm they are secure and free from damage. Additionally, inspect the lock's programming or settings. Confirm that user codes or access credentials are programmed correctly and that any remote control devices are paired and functional.