Top-rated well and pump technicians.

Best well and pump technicians near Breen, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Breen, CO?

Select your specific project to find the pro for you.

TRUSTED BY BREEN, CO HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon11
    Verified well and pump services reviews

Verified Reviews for Well And Pump Service pros in Breen, CO

*The Angi rating for Well And Pump Service companies in Breen, CO is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

*The HomeAdvisor rating for Well And Pump Service companies in Breen, CO is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

Last update on August 06, 2026

Top-Rated Well and pump technicians in Breen - Updated Nov 2026

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,680
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Breen, CO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Request Quote
A Plus Plumbing And Heating LLC
4.0(
4
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Breen, CO and surrounding areas

In business since 2015

Free estimates

Emergency services offered

"Went well as could be expected, needed a part and ordered, when part came in found out we needed another part which delayed fixing our heat for almost a week in total, but having a carrier unit and not having parts in town is what made it difficult, not A+ plumbing and heating. I will be hiring for all future plumbing and heating work!"
Recommended by75%of homeowners
Request Quote
Wells and Pumps FAQs, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Yes, most professional repairs include checking for leaks, sealing connections, and ensuring proper drainage.

There are many signs to look for that will tell you when your irrigation pump is burned out. This may include low water pressure, sprinklers that sputter a lot before turning on, discolored or dirty water, or a pump that stops working altogether. If your pump has any of these issues, it is probably time to replace it.

A leaking well pipe is quite different from if the well itself is leaking. To seal a leaking well, pour a cement mixture or bentonite into the space between the well casing and the borehole wall. The heavier cement collects at the bottom to form a solid seal, pushing lighter materials like mud and fluids up toward the surface. Professional well installation companies have the equipment to do this properly. 

Consider replacement if the pump is over 10 years old or has recurring, costly issues.

The Breen, CO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles