Get matched with top ev charger installation pros in Aspen, CO

"-"

"Top Notch was able to complete our project ahead of schedule and under budget. Their workmanship was quality and performed with care. This was specialty work and they had the experience and mindset needed to complete the project."

"Excellent 1 service call completion."

"I hired this company to build a new deck in the beginning of July. It is now the middle of September and my deck is still not finished. While the time frame is not completely their fault due to material delivery they wouldn’t show up for days at a time when material was available to work with. There were times they would show up and only stay for a couple hours. The whole process was a nightmare. Their lack of quality shows in all areas of the deck. I drafted the plans myself and they were approved by the building department. I provided them with copies of the plans. They messed up 4 of the 5 concrete piers because they measured them wrong. Instead of redoing them. They poured square pads over them that were only poured on the surface for three of them. One of the outside piers was supposed to be 10 inches. They messed up the measurement then poured a 16 inch pier over it that is approximately 1.5 ft above ground. They also cut a sprinkler line that went through the pier instead of pouring over it like I explained to them. I had to replace one piece of siding that met with the deck. I bought matching siding to replace it. The workers broke the siding while moving it. They bought new siding that was cheaper and did not match the existing siding. They additional broke off another small piece of siding that was not fixed. They left material all throughout my yard for weeks, leading to my grass dying and my sprinklers unable to work because they were covered up. Nails and screws were everywhere until I picked them up. The posts were cut short for the railing, so they nailed pieces of extensions on top of the posts. They messed up fastener spots for the rails leaving holes in the railing. They originally used screws for the framing. They had to be replaced with nails even telling them before they started nails had to be used and it was in the plans from the building department as well. They used facia board for the steps until I explained to them what the facia boards were for. Leading me to be short on facia boards for the rest of the deck. They also started the deck flooring using a facia board, realized the mistake and replaced. But at that point the facia board could not be used elsewhere as it was notched for posts. I bought flashing for the ledger that was never used. When I questioned them about it he stated the siding and ledger were already put on. The quality of work was below average at best. They cut corners and I found it very concerning I had to explain to them parts of building a deck."

"Your attention to detail and commitment to excellence are clearly reflected in your work. You consistently deliver high-quality work and I was very pleased to have hired Reyes Electric . I will definitely hire them in the future and will recommend them to everyone! Thank you Reyes Electric you met all my specifications!"

"Great work"

"They charged me almost $500 for a job that took them less than 30 minutes. They're explanation of the job was not detailed when I made my initial phone call and they charge $75 to drive there $150 to tell you what is wrong and $250 to do the job. There is no hourly rate, but they say they have one. They don't tell you that each job has its own price."

"Confluence was quick to respond, quick to install, and months later, I am 100% satisfied with the service!!! Amazing work!"

"I really enjoyed the work by these Networking/Ethernet folks. A different provider had quoted me an $800-1000 project and said I needed Cat 6 cabling for ethernet, when really my existing Cat 5E was fine. All it took was ~$100 and one hour for parts and labor and I now have ethernet ports in every room that support Gigabit speed. Thanks again! Couldn't be happier with this."

"Fast, clean and solved all my pronlems"