Get matched with top above ground pool installation pros in Fowler, CA

The best way to dissolve algae is to use pool shock. The shock increases the free chlorine levels in your pool, which in turn kills bacteria, microorganisms, and algae. You can opt for granulated shock that you mix with water or a premixed liquid shock.

Keep in mind that using pool shock is just one of the steps you need to take to get rid of algae from your pool. Unless you also brush, vacuum, and clean the filter, your algae problem may return.

While you should avoid draining an above ground pool on a regular basis, it may be necessary if you are experiencing common signs of major pool problems. When you fully drain your pool, do so slowly with the proper equipment and always avoid draining on a very hot day. In many cases, the pool liner and equipment depend on the cooling effect of the water.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

If your pool takes longer than one or two days to fill, you might be dealing with low water pressure. Using a water pressure gauge on your outdoor tap, you can check your water pressure. A reading of 40 psi or below is considered low. A leak, a nearby water shutoff, or several other reasons could cause this. 

If the water pressure isn’t a problem, you could have a low flow rate from clogs, corroded pipes, or other plumbing issues. It’s best to call in a local plumber to get to the root of the issue.