Get matched with top siding pros in Safford, AZ

If you have stucco on the outside of your home, it’s technically considered cladding and not siding, but beyond that, it’s impossible to tell without a little digging. Without damaging the siding material, expose part of it to see if there’s an air gap between the siding and your exterior wall. If there is, you have cladding. If the siding is affixed directly to the exterior wall, you have a simple siding system.

There should be small gaps between your roof and the walls of your home, and other buildings. These small gaps let building materials shift, expand, and contract with weather and other outside forces, and they prevent moisture from wicking down walls from roofing and gutter systems. Without these strategic gaps, your home’s exterior and its finishes can sustain water damage, decay, peel, delaminate, and crack. However, there is a fine line between a smart gap and a problematic gap—all  gaps should be small, intentional, and covered or filled in with foam insulation to prevent pests from using them as access points.

You should plan to stain or refinish your home's cedar siding every three to seven years to maintain its appearance and provide maximum protection, though some estimates suggest a range of four to six years. The exact frequency depends on several factors, including your local climate, exposure to severe weather like direct sunlight, rain, and wind, the quality of the initial stain application, the type of stain used, and the overall condition and quality of the wood.

For homes in harsh climates with high humidity and significant sun exposure, you should plan on staining as often as every three years, while those in milder locations may only need to do so every seven years. For the longest-lasting protection in particularly harsh climates, consider using an opaque stain.

If you are looking for a lower-maintenance alternative, you might consider vinyl or aluminum siding. While the initial installation cost can be higher, they do not require as much upkeep and can offer more value over time, especially in areas with excessive rainfall or high humidity.

You may only need to repaint fiber cement siding every decade or so, but you should clean it every six to 12 months, depending on your local climate. First, wash with a garden hose or similar low-pressure device (not a high-pressure washer, which can damage the material) to remove dirt and any large debris. Then, gently wipe down the surface with a soft brush or cloth in a side-to-side motion, following the grain of the fiber cement.