Get matched with top roofers in Bauxite, AR

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

No, you can’t use your home’s square footage. You have to calculate your roof’s square footage, and then you may have to convert your square footage measurement to correspond with how the roofing material is measured. For instance, some roofing is sold in “squares,” which equals the total square footage of the roof divided by 100. Shingles are sold in bundles that may not correspond to the number of squares you need. Metal roofing is sold as sheets, so determine the amount of square feet each panel will cover and then divide the total square footage by the coverage area.

A chimney cap costs about $300 on average to install, with prices ranging from $75 to $1,000. The final cost depends on several factors, including the professional you hire, the accessibility of your chimney, the cap's material and size, whether any repairs are needed, and if it requires custom fabrication. Chimney caps are usually made from galvanized steel, stainless steel, or copper. Copper caps are the most expensive, followed by stainless steel and then galvanized steel. Excluding labor, average material costs are around $100 for galvanized steel, $250 for stainless steel, and $600 for copper. You may also face additional costs, such as hiring a chimney sweep to clean the chimney before the cap is installed.

Metal roofs have a reputation for being noisy, but with proper installation and adequate insulation, they are not significantly noisier than shingle roofs. The type of metal used can affect the sound level; for instance, steel roofs are typically noisier than slate or asphalt tiles but quieter than aluminum. While some people find the sound of rain on a metal roof pleasant, you can take steps to reduce the noise. Installing a thicker underlayment, adding insulation between the roof and the house, or using acoustic tiles can effectively muffle the sound. The gauge (thickness) of the metal roofing can also contribute to sound dampening.