Get matched with top plumbers in Altheimer, AR

That pesky faucet leak can have a few different causes, most of which are standard wear and tear that occurs over time, but that doesn’t make it any less annoying, especially when the energy bill hits:

• Old washer: A deteriorated washer or gasket is the most common cause of a leak. Luckily, it’s easy and affordable to fix.

• Old packing nut: There’s a chance the packing nut (located beneath the handle) is loose and simply needs tightening, or it has been worn down, stripped, and needs to be replaced.

• Freezing temperatures: The water sitting in your spigot over winter can freeze, expand, and lead to damage and leaks.

• High water pressure: High water pressure is hard on pipes over time and can cause cracks and leaks, too.

It is best practice to hire a plumber to install a bathroom sink and vanity. Even simple installations require basic plumbing work, such as connecting water supply lines and attaching the sink to the drainage system. While an experienced DIYer might manage a straightforward setup, any complex work, like modifying existing plumbing or installing new lines, should always be left to a licensed plumber to avoid the risk of expensive water damage. In most cases, a plumber will handle the installation, provided it is a straightforward job that does not require custom carpentry. It's important to outline your expectations with the plumber beforehand to confirm they can handle the full project.

If you're dealing with a clogged sink drain, you may be able to avoid removing the drain by using a plunger to dislodge the clog. While we associate plungers with toilets, they can do the same job with your sink drain. Be gentle, though, as forceful movements can push clogs further into your plumbing system and make them more difficult to remove. Additionally, make sure you’re using a sink plunger—with a flat bottom—and not a toilet plunger—which has a smaller bottom protruding from the larger flat piece.

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.