Get matched with top stone and gravel pros in Chapman, AL

Limewash can be removed from brick, but the method of removal will depend on how long the limewash has been on the brick. If the limewash has fully dried—which happens after about five days—you’ll need to use a diluted muriatic acid mixture to remove it. If there are multiple coats of limewash, you may need to apply the acid mixture several times to fully remove it from the brick.

Spalling brick is not uncommon, but it does indicate a serious issue. It can be caused by water damage, an intense freeze-thaw cycle, or something else. Painted bricks can be susceptible to spalling, as the paint doesn’t allow the porous material of the brick to breathe, which can trap moisture. Spalling should always be addressed immediately before more serious structural damage occurs.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

Handbuilt masonry fireplaces are likely what comes to mind when we think about curling up by the fire at the end of the day. But bricks in the firebox and chimney tend to be heavy, which is not ideal for homes with weak or damaged foundations.

Prefabricated fireboxes come with a full flue and chimney system, significantly reducing the price and installation time. However, if you need to replace the panels down the line, you are locked into the same model or something very similar.