Get matched with top electricians in Grant Town, WV

The key difference between a circuit breaker versus a surge protector is that circuit breakers shield your entire electrical system from overcurrents and faults, while surge protectors defend your electronic devices against voltage surges and spikes. A circuit breaker interrupts the flow of electricity in a circuit when it detects an overload or short circuit, protecting the wiring from damage and preventing fires. In contrast, a surge protector shields electronic devices from voltage spikes, such as those caused by lightning strikes or power surges, preventing damage to the device’s inner mechanics.

To determine if an electrical outlet is blown, look for visible signs of damage such as a burning or smoky smell, burn marks, or a melted or discolored plastic cover. If you notice a burning smell, contact an electrician immediately. Other signs include a plug that keeps falling out or the outlet not working when you test it with different devices. For further troubleshooting, you can use a voltage tester or multimeter to check for power; a reading of zero indicates a problem. Also, check your circuit breaker or fuse box to see if the circuit was tripped and reset it if necessary. If these steps don't resolve the issue, the outlet may need to be replaced.

Yes, if something sparks when you plug it in or turn it on, it's important to unplug it immediately. A spark from an electrical appliance or device could indicate a short circuit, damaged wiring, or other electrical problems that could cause electrical fires or electrical shock. By unplugging the appliance, you can reduce the risk of electrical hazards and prevent damage to the device itself. It's important to avoid using the appliance until it has been inspected and repaired by a licensed professional to ensure that it’s safe to use.

A ceiling light will usually have two or three wires: black, white, and sometimes green. Black wires are positive, or hot, while white wires are negative, or neutral. The green wire is the grounding wire. 

When you’re wiring the light, connect black to black, white to white, and green to the grounding screw.