Get matched with top toilet pros in Barnet, VT

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

While you shouldn’t increase the flow of your low-flow toilet by adjusting the water level in the toilet bowl set by the manufacturer, you can make the flow as efficient as possible by ensuring the rim jets under the rim are unobstructed. To do this, use a mirror to look under the rim and scrub them with a toothbrush or a small wire to clear any debris stuck in the holes. You can also watch for leaks, make sure the internal components are in good shape, and replace them if necessary.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

The toilet flange anchors to the subfloor, usually with wood screws or cement screws, but most of it should sit above floor level at full height. When a flange is flush with the subfloor or below it, it can lead to the creation of leak paths.