Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Max Meadows, VA

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Max Meadows, VA?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Max Meadows

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Max Meadows, VA and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools questions, answered by experts

You can spend less time and money on plunge pool maintenance since they are smaller than standard pools. These pools are easier to clean and maintain yourself than a swimming pool. But like any pool, you’ll need to clean the pool walls and floor, balance the chemicals, check the electrical equipment, make necessary repairs, etc.

Detecting a leak in your pool costs about $300 on average. The price ranges widely from low $100 up to $1,000. Here are the costs involved in leak detection services for your pool:

  • Pool inspection: $125–$250

  • Above ground pool leak detection: $100–$700

  • Inground pool leak detection: $400–1,000

  • Vinyl liner repair: $350–$3,600

  • Fiberglass lining repair: $300–$400

  • Concrete liner repair: $75 per linear foot

  • Pressure test pool lines: $200–$500

  • Skimmer repair: $100–$250

  • Main drain repair: $400–$700

  • Pump repair: $50–$300

  • Tile repair: $20-$30 per linear foot

If you put too much baking soda in your pool, your alkalinity will rise. That means you’ll need to take steps to lower your alkalinity. You can either add more water (which will require more chemicals because they’ll be diluted), wait for the alkalinity to lower naturally, or use a chemical like muriatic acid to lower it. 

Yes, you should keep your pool pump running when adding salt, and leave it running for 24 to 48 hours. This will help circulate the salt to ensure even distribution. You will want to turn off your pool’s salt chlorine generator before adding salt and leave it off until it fully dissolves. Check your manufacturer’s instructions for steps specific to your saltwater pool maintenance.

Once you use a pH decreaser, you can expect the pH to adjust in two to four hours. If you use a strong chemical like muriatic acid, it could take as little as an hour. Either way, it’s best to wait for a full turnover cycle before retesting. You want to make sure the chemical is completely dissolved and evenly distributed or you won’t have a stable pH level.

The Max Meadows, VA homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.