Top-rated toilet pros.

Best toilet pros near Aneth, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Aneth, UT?

Select your specific project to find the pro for you.

Top-Rated Toilet pros in Aneth - Updated Nov 2026

Replumb Specialties Inc.
3.9(
9
)
Faucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Aneth, UT and surrounding areas

In business since 1992

Free estimates

Warranties offered

"RSI is a great replumb company. The actual replumbing was outstanding and we opted for the upgraded pro-plex fittings to increase our warranty from 10 to 25 years (not an up sell by Jamey - our choice). They also put in-place a dedicated recirculation line for our tankless water heater. The RSI team (Kenny and Milo) was expert at locating and replacing the old polybutylene piping with minimal impact to sheetrock, tiles, and fittings. They finished the work early but were delayed in finalizing the project due to a delay from the Regional Building Inspectors, not RSI's fault. Our only suggestions are 1) better daily clean-up, 2) better attention to detail repainting sheetrock (we had to repeatedly point out areas for a 'redo' and adjacent areas for touch-up) - this seemed harder to do that we expected (this is why we gave them a B rather than an A for quality). Jamey was very responsive to us and answered our questions/concerns thoroughly and promptly. We will recommend RSI our neighbors and friends.
"
Recommended by85%of homeowners
Toilets FAQs, answered by experts

Installation costs range from $150 to $400, depending on toilet type and labor.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

A toilet flapper will remain open when the chain that it is connected to is too short. The chain should lift the flapper just enough to allow it to open the rest of the way on its own. The chain should have just about half an inch of slack.

On average, it costs between $150 and $300 to fix a toilet that’s leaking at the base, including supply charges. If the flange is intact, the cost is between $150 to $200. If the flange needs to be replaced, you can expect an extra $50 or so. The actual price will depend on the hourly rate your plumber charges.

The amount of water wasted when a toilet ghost flushes depends on the cause of the ghost flushing. Leaky flapper valves tend to waste less water than a larger problem like a damaged flush valve that makes the toilet run constantly. Even if you don’t think you’re wasting a lot of water, it’s still a problem that should be fixed quickly. 

The Aneth, UT homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.