Best roofers near Nacogdoches, TX

While the terms are often used interchangeably, wood shakes and wood shingles have notable differences, primarily in their manufacturing and appearance. Wood shingles are machine-cut on both sides, resulting in a smooth, thin, and uniform product. In contrast, wood shakes are typically hand-split or sawed on only one side, giving them a more textured, natural, and rustic appearance. Due to these manufacturing differences, shakes are generally thicker, heavier, and less uniform than shingles. They are also more expensive. Homeowners seeking a more rustic aesthetic often choose shakes, while those preferring a more uniform look may opt for shingles. Both are installed in an overlapping pattern to create a durable, weather-resistant roof.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

The purchase price of 3-tab shingles is less than that of other material varieties, such as architectural shingles. However, 3-tab shingles generally last far fewer years than even the least expensive architectural ones. Other roofing types, such as metal or clay, also cost more than 3-tab shingles. However, if you plan to stay in your home for many years, the long-term cost of any of these options can compete with 3-tabs because of their longevity.

16-gauge galvanized steel staples with a minimum crown of 15/16 inches or 24 millimeters are occasionally used to install shingles. However, most shingle manufacturers or residential building codes don’t recommend staples as a roofing fastener. Roofing nails are preferred in most cases, especially in areas that get a lot of heavy wind.