Top-rated drywall pros.

Get matched with top drywall pros in Gonzales, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Gonzales, TX?

Select your specific project to find the pro for you.

Find Drywall pros in Gonzales

Avatar for Bernabe&sons drywal
Bernabe&sons drywal
3.0(
1
)
Drywall - InstallDrywall - Repair

Serving Gonzales, TX and surrounding areas

Approved

Free estimates

Emergency services offered

Small jobs welcome

My name is Bernardo bernabe i have been in the drywall business for about 7 years.\nI do jobs all over the san antonio area and surrounding areas I specialize in doing remodels and new construction houses, including small patch work, no job is ever too small or too large, text for a free quote!

Avatar for AM home improvements
AM home improvements
New to Angi
Drywall - InstallDrywall - Repair

Serving Gonzales, TX and surrounding areas

Approved

Small jobs welcome

Army Veteran with 5+ years experience in rough and finish carpentry, handyman work, fabrication, and mechanical knowledge. Looking to service the New Braunfels and surrounding area with quality craftsmanship and service!\n\n

Porch facelift.
Porch facelift.
Porch facelift.
Porch facelift.
Porch facelift.

+3

15 neighbors recently requested a quote
BluSky NM Drywall Lath & Plaster Inc
4.8(
249
)
Drywall - InstallDrywall - Install - For BusinessDrywall - Repair+1 more

Serving Gonzales, TX and surrounding areas

In business since 1994

Free estimates

Emergency services offered

"The crew showed up every morning on time. They patched/drywalled and textured numerous small areas. The texturing was so good, that it is almost impossible to detect where the repairs where made. They also framed, drywalled and textured the kitchen area for recessed lighting installation. They repaired an area where there was a shower leak. They replaced the drywall and textured an area where a closet had been removed. On every part of the project, they exhibited superior workmanship. And at the end of every day, they cleaned up after themselves. Hire them again? Definitely yes! 
"
Additional Photos
Additional Photos
Additional Photos
Recommended by98%of homeowners
...
Showing 1-10 of 81
Drywall questions, answered by experts

The short answer is yes, a sagging plaster ceiling is dangerous. Sagging plaster on a wall is something you should fix immediately, but it isn’t a major concern. If the same type of sagging occurs on a ceiling, however, you could be in danger of your ceiling falling in large chunks. When plaster sags, it loses its strength and ability to hold itself up. The bonds that hold it together are strong, though, so if a sagging area falls, it will take large pieces down with it.

Plaster ceilings can sag for several reasons. In some cases, the plaster and other building materials shift and come apart over time, which is why you’ll commonly find drooping plaster ceilings in older homes. Improper installation, foot traffic, and water damage—often from a leaky roof or a broken pipe—can also cause plaster ceilings to sag.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Brick and stucco are a lot more different. You must use picture hanging clips designed for brick walls, or use a plaster rail system with adjustable hooks. Any other type of hanging hardware will cause damage to the bricks behind. You won’t be able to really use nails, either, because they’re not strong enough to go into the bricks.

While every home has its own unique needs, ceiling drywall installation typically follows a staggered or stepped pattern to enhance structural integrity and reduce the visibility of seams. Starting from one corner, sheets are placed perpendicular to the ceiling joists, with the ends of adjacent sheets meeting along the center of the joist. The next row begins with a half sheet, ensuring joints don't align vertically. This alternating pattern, combined with proper taping and mudding, creates a seamless appearance and strengthens the ceiling structure, minimizing the risk of cracks over time.

The Gonzales, TX homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.