Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Abilene, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Abilene, TX?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Abilene

Avatar for RC Concrete
RC Concrete
4.7(
18
)

Serving Abilene, TX and surrounding areas

In business since 2020

Free estimates

Small jobs welcome

"The office called me very quickly. Their service was extremely professional and priced accordingly. Iâ ll call them anytime I need any type of masonry work in the future!"
Patio Addition
Patio Addition (before picture)
Exterior patio
Extended Driveway
Extended Driveway

+7

Response time1 day
Response rate98%
Recommended by93%of homeowners
Avatar for Mammoth Coatings
Mammoth Coatings
4.2(
5
)

Serving Abilene, TX and surrounding areas

In business since 2018

Free estimates

Credit card accepted

"I hired this company to resurface my 3 car garage. I was shocked to find I could have a glossy design for my budget... instead of just having my concrete fixed up. Thank you Mammoth!"
Einstein Bros Bagels
Chips
Garage Floor with Chips
Chips
Joint Fill

+6

Response time2 days
Response rate89%
Recommended by100%of homeowners
Showing 1-10 of 43
Epoxy Flooring questions, answered by experts

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.

It costs between $600 and $8,400 to stain an average-size concrete patio of around 300 square feet. The wide price range accounts for intricate stains that incorporate multiple colors and stenciling, high-end sealers, and special touches, such as stamping or concrete polishing. Prices can also vary if you need to make multiple repairs to your patio before adding the stain and seal.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

In most cases, yes, sealing concrete will stop spalling. However, it’s not a perfect solution—it may only delay spalling. Call your local concrete repair contractor for quotes on the best sealing options to prevent spalling.

It depends on the type of sealer. Some sealers can dry in as little as 4 hours, but many can take up to 48 hours to fully cure. To play it safe, don’t drive on your driveway for two days after sealing.

The Abilene, TX homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.