Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Roscoe, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Roscoe, TX?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Roscoe

Avatar for Mammoth Coatings
Mammoth Coatings
4.2(
5
)
Concrete Floor Coating-Apply - For Business

Serving Roscoe, TX and surrounding areas

In business since 2018

Free estimates

Credit card accepted

"I hired this company to resurface my 3 car garage. I was shocked to find I could have a glossy design for my budget... instead of just having my concrete fixed up. Thank you Mammoth!"
Einstein Bros Bagels
Chips
Garage Floor with Chips
Chips
Joint Fill

+6

Response time2 days
Response rate89%
Recommended by100%of homeowners
Avatar for West Texas Epoxy and Concrete
West Texas Epoxy and Concrete
New to Angi
Concrete Finishing, Overlays & Coloring - ApplyConcrete Floor Coating-Apply

Serving Roscoe, TX and surrounding areas

In business since 2022

Free estimates

Emergency services offered

West Texas Epoxy and Concrete is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Showing 1-10 of 15
Epoxy Flooring questions, answered by experts

Self-leveling compound usually requires up to 24 hours to dry before you can begin installing tile. It’s best to follow the instructions on the self-leveling product label for appropriate dry time. If you’re still not sure, play it safe and give the self-leveling compound two days to dry before you begin the tiling process.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.

It takes time for damage to accumulate on garage floors. After years without maintenance, they will show cracks, stains, and moisture damage while collecting layers of dust along the surface.

You primarily need to be concerned about the moisture level in concrete when you are dealing with a basement or other below-ground part of your house. If you find any indication of moisture in your subterranean space, consider calling in a professional for further testing and moisture control solutions.

The Roscoe, TX homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.