Get matched with top concrete resurfacing pros in Pierre, SD

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

A concrete overlay on an existing slab can range from 1/4 of an inch to 2 inches thick, though a minimum of 2 inches is often recommended to ensure stability and quality. The ideal thickness depends on the condition of the existing concrete and the depth of any planned designs or imprints. Before applying the overlay, it's important to repair and clean the surface, then apply a primer. For specialized work like a stamped concrete overlay, hiring an experienced contractor is recommended to determine the correct thickness and ensure the new layer isn't too high or heavy. For context, most standard concrete slabs are between 4 and 6 inches thick.

The typical cost to resurface a patio is around $4 per square foot, or about $400 for a 100-square-foot patio.