Get matched with top concrete resurfacing pros in Onida, SD

Concrete blemishes such as chipped steps or small cracks are fixable with patching. For bigger jobs, including driveway repair and cracks wider than a 1/4 of an inch, patches will only serve as a temporary fix. Resurfacing is ideal when the surface is showing more widespread wear—like if it’s pitted, rough, or has lots of cracks. Resurfacing gives your concrete a fresh, like-new appearance without needing a full replacement.

When the concrete is severely cracked, sinking, or otherwise structurally unsound, replacing it might be your best option. Replacement ensures the safety and longevity of the surface in this case.

Whether resurfacing concrete is worth the cost depends on the condition of the underlying slab. Resurfacing can be a good option if the concrete is in decent condition with only minor issues like standard wear and tear, small cracks, chips, or discoloration. In these cases, resurfacing adds a protective layer that can extend the concrete's lifespan without the high cost of a full replacement.

However, if the concrete has significant damage—such as deep cracks, peeling, sinking, or is broken up—resurfacing may not be worth it. The new overlay is only as good as the concrete beneath it, and existing problems like peeling and cracks are likely to show through the new surface. In situations with severe damage, replacing the entire slab is often more cost-effective in the long run and will yield a better result.

To make the best decision, it's recommended to have a licensed concrete specialist inspect the damage and determine if resurfacing is the right choice for your situation.

Visible cracks, scaling, flaking, and uneven surfaces indicate a bad concrete job. Additional signs vary depending on the project. You may notice poor drainage or even exposed rebar. Quality issues result from using the wrong concrete, rushing the work, or inexperienced workers completing the job.

You'll find a slurry of natural and synthetic polymers, rubbers, epoxies, and resins used to bond old concrete to new concrete. The right bonding agent depends on the method of concrete pouring you choose and whether you're adhering concrete over concrete or concrete over sand and gravel. Some concrete resurfacing mixtures contain bonding chemicals as well.