Best concrete resurfacing pros near Avon, SD

Address drainage issues, avoid heavy loads, and seal cracks to prevent future settling.

If there is standing liquid on your concrete, remove it before attempting any of the above cleaning methods. For small amounts of water, use rags, a bucket, and a mop. For larger areas of liquid, lay down cat litter or baking soda to soak up the water first. If you have extremely large pools of water sitting on your concrete, break out the wet vac and get to work.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

If your concrete steps have crumbled or chipped, you can fix them by removing any chips or flakes, cleaning and wetting the affected area, applying a concrete bonding agent, and finally applying new concrete, usually in the form of Portland cement. For widespread damage, you can consider concrete resurfacing instead. For fixing concrete spalling that has led to deep damage, you might need to remove damaged material, add structural supports, and pour new concrete into a mold.