Get matched with top epoxy flooring pros in Greer, SC

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Sealing resurfaced concrete is not an absolute necessity. However, it is recommended, and in most cases, a high-quality concrete sealer can protect the surface from stains as well as water penetration, extending the life of the resurfacing material. Some sealers are formulated to protect pigments from fading due to UV exposure. Sealer tends to enhance the colors in decorative resurfacing applications, making them more vibrant and richer compared to the duller, more faded appearance of concrete colors without sealer.

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

Spills like water, oil, or grease can wear down the epoxy's strength, lowering its lifespan. While this damage doesn’t happen immediately, it can accumulate over time, so cleaning up any garage spills as soon as they happen is essential. Avoid cleaning with or using dish soap on your epoxy floors since they will leave an unattractive residue. Instead, you can use half of a cup of ammonia diluted with a gallon of water for cleaning purposes.