Top-rated drywall pros.

Get matched with top drywall pros in Topton, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Topton, PA?

Select your specific project to find the pro for you.

TRUSTED BY TOPTON, PA HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon32
    Verified drywall services reviews

Find Drywall pros in Topton

James R. Weisbrod Drywall
5.0(
4
)
Drywall - InstallDrywall - Install - For BusinessDrywall - Repair - For Business

Serving Topton, PA and surrounding areas

Approved

In business since 1985

Free estimates

Customers say: Quick response

"Our powder room walls had some damage underneath wallpaper. We needed the drywall removed, replaced and spackled as well as two medicine cabinet holes filled in. They did such an amazing job! And I am picky with work."
Garage
Vaulted Ceiling
Family Room
Family Room
Response time6 hrs
Response rate89%
4 neighbors recently requested a quote
Avatar for Rubivar Drywall, Inc.
Rubivar Drywall, Inc.
5.0(
3
)
Drywall - Repair - For BusinessDrywall - Install - For Business

Serving Topton, PA and surrounding areas

Approved

In business since 2021

Free estimates

Credit card accepted

"We had our family room drywalled and they did a excellent job. Very professional and friendly. Answered all questions about work they would perform and the quote was very reasonable. They were fast but did a very good job."
Response time30 mins
1 neighbors recently requested a quote
Recommended by100%of homeowners
...
Showing 1-10 of 273
Drywall questions, answered by experts

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Costs depend on damage size, labor rates, and whether additional services like painting are required.

When you are learning how to tape and mud drywall, waiting for things to dry requires a lot of patience. So how long does drywall mud take to dry? On average, it takes about 24 hours. However, it depends on things like the thickness of the mud, as well as the room’s temperature, humidity, and ventilation. Using thin layers of mud in a warm, low-humidity room with good airflow reduces average drying time. You also could speed up drying time by making use of hot drywall mud, which consists of a powder that you mix with water, instead of using pre-mixed mud. 

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

Through expert matching of texture and paint for an invisible repair.

The Topton, PA homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.