Top-rated backsplash installation pros.

Get matched with top backsplash installation pros in Morris, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your backsplash installation project in Morris, PA?

Select your specific project to find the pro for you.

TRUSTED BY MORRIS, PA HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon13
    Verified backsplash installation services reviews

Find Backsplash installation pros in Morris

Showing 1-10 of 23
Backsplash Installation questions, answered by experts

There are no unbreakable rules of design, but experts recommend against using large tiles in areas with poor subflooring where they’re more prone to cracking, in areas where the floor isn’t entirely level, over raised areas or dips, and in bathrooms where budget is the primary concern. The size of your bathroom shouldn’t be a reason not to use large tiles; in fact, larger tiles, also known as slab tiles, can be a modern and sleek choice for bathroom floors and walls.

Yes, you can install a backsplash directly onto drywall, provided the wall is properly prepped, clean, and dry. For best results, especially in kitchen areas, your walls should be made of moisture-resistant drywall, often called green board. If your current wall isn't moisture-resistant, it's recommended to replace it before installing the backsplash. For even greater protection against water damage, you can remove the existing drywall and install a tile backer board or cement board instead. While properly installed standard drywall is typically strong enough to support a backsplash, some local building codes may require water-resistant materials in kitchen areas, so it's a good idea to check.

The tile spacing you should use will depend on the tile and where you’re installing it. Choosing the right tile spacers to maintain a consistent gap between your tiles is tricky. Generally, tile spacing shouldn’t be less than 2 millimeters on walls and 3 millimeters on floors because of stress relief requirements. Getting it wrong can result in uneven tiles and early repairs.

If the hearth ends against a wall, you can use a tile cutter as you normally would. However, if the edge of your hearth ends with no surface pressing against it,you may want to look into rounded tiles. These give a smooth edge to your hearth and make sure cut edges aren’t visible. You can also see if the tile you have has pieces that have been glazed or rounded on one edge. You’d then cut the tile and place it normally, with the cut edge facing inward. 

It’s possible to walk on a clay tile roof, but you run the risk of breaking or cracking the tiles if you’re not careful, so it’s best not to walk on it if you can avoid it. If you or a contractor needs roof access, be sure to distribute your weight evenly and step on the portions of tile that are also supported underneath, which depends on your tile design. Walking on any roofing material is inherently dangerous, so wear rubber-soled shoes and use safety equipment if you need to access your roof.

The Morris, PA homeowners’ guide to backsplash installation services

From average costs to expert advice, get all the answers you need to get your job done.