Get matched with top roofers in Monroeville, PA

Yes, removing a chimney is a difficult and major undertaking. Chimneys often provide structural support to a home, so if it's a load-bearing structure, you'll need to take extra precautions to maintain your home's integrity. A project of this complexity typically requires a structural engineer, a masonry contractor, and a demolition crew. The removal process may involve taking the chimney out brick by brick from inside the walls. The cost for chimney removal can range from $2,000 to $10,000, depending on the job's complexity. Due to the difficulty and cost, some homeowners opt to remove the fireplace and seal the chimney at the top and bottom, sometimes also removing the visible exterior portion at the roofline.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

You may become so frustrated with the look of moss on your roof that you contemplate whether to clean or replace your roof. Fortunately, you don’t have to go as far as replacing it. After cleaning the moss, you can use a chemical solution to keep it away. For further protection, trim branches that overhang the roof, as fallen seed pods and leaves on the roof allow moisture to collect, encouraging moss growth. Consider adding zinc-coated flashing to the roof, too. As rain washes across the zinc, it leaves zinc particles behind that inhibit moss growth.

Whether you should choose a flat roof or a sloped roof depends on your particular situation. Flat roofs tend to be less expensive to install. However, sloped roofs have longer lifespans and stand up better to heavy snow and other inclement weather.

Keep in mind that even a flat roof needs to have a slight slope, usually around 1/2 inch for every foot. If it is completely flat, water will pool and cause damage, either from weight or leakage or rot.