Top-rated drywall pros.

Get matched with top drywall pros in Jacksonville, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Jacksonville, OH?

Select your specific project to find the pro for you.

Find Drywall pros in Jacksonville

Avatar for A&D Renovations
A&D Renovations
5.0(
5
)
Drywall - InstallDrywall - Repair

Serving Jacksonville, OH and surrounding areas

Approved

In business since 2025

Free estimates

Credit card accepted

"A&D Renovations completed each piece of the job, 3 ceiling fans, removed amd rehung mantle piece securely, and fixed two downspouts. They ensured we were happy with each item and asked questions to make sure on the same page. I appreciated they arrived when Brian said would and completed timely within their quote."
Handicap ramp
Handicap ramp
Handicap ramp
Handicap ramp
Handicap ramp

+3

48 neighbors recently requested a quote
Avatar for Creative Painting and Design
Creative Painting and Design
5.0(
2
)
Drywall - InstallDrywall - Repair

Serving Jacksonville, OH and surrounding areas

Approved

In business since 1990

Free estimates

Customers say: Quick response

Creative Painting & Design is your go to for all of your painting and drywall service needs. Servicing Washington County, there is no job too big or too small. We pride ourselves on our quality work and can guarantee our customers satisfaction 100% of the time. Give us a call today to get your project started!

Gallery
Response time4 hrs
15 neighbors recently requested a quote
Recommended by100%of homeowners
...
Showing 1-10 of 72
Drywall questions, answered by experts

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

There is no way to cut drywall without making dust, but you can reduce the amount of dust and especially the dangerous airborne particles by using manual cutting tools. Using a utility knife to score and snap your drywall will minimize dust production, and a jab saw for cutting cutouts for boxes and fixtures will generate almost no airborne dust. Even if you use these methods, you should still wear a respirator and safety goggles to avoid damage to your lungs and eyes.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

Regular inspections, repainting, and avoiding moisture exposure help maintain integrity.

Yes, any parts of drywall that are wet or overly moist will need to be replaced. Drywall is intended to be dry (it’s in the name, after all.), as excess moisture can lead to mold and mildew and eventually corrode your home’s foundational building pieces. Do regular inspections in your home to make sure all your plumbing is intact and in good condition—this will go a long way toward preventing leaks.

The Jacksonville, OH homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.