Top-rated well and pump technicians.

Get matched with top well and pump technicians in Huron, OH

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Huron, OH?

Select your specific project to find the pro for you.

Find Well and pump technicians in Huron

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Huron, OH and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Huron, OH and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

There are many signs to look for that will tell you when your irrigation pump is burned out. This may include low water pressure, sprinklers that sputter a lot before turning on, discolored or dirty water, or a pump that stops working altogether. If your pump has any of these issues, it is probably time to replace it.

Schedule annual inspections, monitor water pressure, and address minor issues promptly to avoid major repairs.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

If you have a well-related issue, such as your well water stopping, you should hire a local water well contractor or a well and pump repair professional. These specialists handle all aspects of wells, including the pump, tank, and other outdoor water pumping equipment. They can inspect your system, recommend and perform repairs, and even coordinate a water quality test if needed. While plumbers are experts in indoor plumbing, they may not have the specialized experience with residential wells that a dedicated well contractor does.

The Centers for Disease Control and Prevention (CDC) recommends testing your well at least once a year to check for bacteria and contaminants. If you live in an area prone to flooding, runoff, or any other environmental concerns, it can be a good idea to check two to three times per year.

The Huron, OH homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.