Best toilet pros near Burbank, OH

Sealant doesn’t need to be applied to the bolts, but it can be a good way to stop an active leak in the moment. However, don’t rely on it as a cure-all; instead, make sure to fix the problem at the source by changing or tightening the bolts. 

If you do use sealant, make sure to spread it thickly and evenly across the bolts and the tank's porcelain.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Toilet handles can get stuck for a couple of reasons, but it’s commonly an issue with the chain. Remove the lid and check the chain’s connection, running from the flapper to the handle arm. Sometimes the chain gets snagged on or against another part of the tank. 

The chain might not have the right tension. For example, a chain that’s too short can make the handle feel stuck. Check that there’s some slack in the chain. Old, worn-out flappers can get stuck, too. In this case, you’ll need to see which size toilet flapper you need.