Get matched with top sonic cleaning pros in Selden, NY

You should avoid using a pressure washer on any surface or item that could be damaged by the high-pressure spray, as some materials are too delicate to withstand the force.

Key items and surfaces to avoid include:

• Electrical Components: Never pressure wash electrical systems, as water can cause short-circuits and create a safety hazard. This includes utility meters, breaker boxes, electrical outlets, generators, and HVAC or air conditioner units.

• Delicate and Fragile Materials: Fragile items can crack, shatter, or be stripped by the pressure. Avoid pressure washing windows, glass, light fixtures, shingled roofs (especially asphalt), and stucco.

• Painted, Stained, or Sealed Surfaces: Unless your goal is to strip the finish, do not pressure wash painted surfaces, stained wood (like decks), or anything with a protective seal that could be stripped away. Be especially cautious with older surfaces that may contain lead paint.

• Soft Woods and Certain Decking: Delicate surfaces like softwood, composite decking, and antique or wooden patio furniture can be etched or damaged. If you must wash wood, use a lower-powered pressure washer with a wide-angle nozzle to prevent damage.

• Living Things: Never use a pressure washer on people, pets, or plants. The force can cause serious injury and will destroy landscaping.

Chemical herbicides will kill moss permanently. The same goes with bleach water. However, moss can start growing again once a new layer of dirt and debris is caught in your sand in paver joints. Therefore, the problem is not about killing moss permanently, but ensuring effective prevention of moss regrowth.

Yes, gable vents can let water in. That being said, this usually only occurs during extreme conditions like heavy rainfall. You can prevent water from entering through gable vents by adding a screen that traps the water before it can enter.

Moss grows in dark areas of roofs, including in corners and gutters. If left alone, it can grow under roofing and cause permanent damage. Here’s how to remove moss from metal roofs: 

• Soak the moss to soften it

• Scrub it away with a soft-bristled brush, or pick it off with your hands (be sure to wear gloves)

• Use a moss remover that’s compatible with metal roofing, following the manufacturer’s directions

• Remove dead moss and rinse the roof thoroughly

• Prevent future moss growth by trimming branches, cleaning gutters, and attaching zinc strips to moss-prone areas