Best electricians near Poughquag, NY

If only half of your outlet works, there are usually two possible causes: faulty wiring or a half-hot outlet. The first thing you'll want to do is check the circuit breaker panel to ensure that it's not tripped. If your circuit breaker isn't tripped, turn off the electricity and inspect the wiring to see if anything has come loose or corroded. 

If you have a half-hot outlet, it means half of the outlet is controlled by a switch somewhere on the same circuit, which should be nearby. This is an intentional electrical design commonly found in rooms without overhead lights.

Single-pole switches are simple circuits designed for lower voltages. As such, they don’t require the complex wiring of switches that need to supply power to larger devices and appliances. This is why single-pole switches commonly go in bathrooms, closets, and other small rooms that power a low-watt light fixture. One wire creates the circuit from the power supply, the other goes to the fixture, and the final wire provides safety mechanisms through grounding.

Most electric water heaters have a built-in shut-off switch, so you can simply turn that to the OFF position. Some water heaters have the switch inside a panel, so you might need to unscrew the panel, remove it, move aside the insulation, and then shut the water heater off. To make sure it’s off, you can also locate the switch for your water heater in your electrical panel and shut the power off there. Most electrical panels have dedicated switches for the water heater, so you can shut off the power without affecting the rest of your home.

You will need a permit for any electrical work that involves installing or replacing wiring, moving or installing new fixtures, switches, or outlets, hardwiring appliances or HVAC equipment, installing subpanels, and upgrading electrical service. You typically don’t need a permit to have an electrician replace an existing light fixture or electrical box. You can always call your local building department to see if your project needs a permit, but a professional electrician will be able to tell you. In most cases, your professional will pull the permits for you.