Top-rated sandblasting pros.

Best sandblasting pros near Acoma Pueblo, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your sandblasting service project in Acoma Pueblo, NM?

Select your specific project to find the pro for you.

Top-Rated Sandblasting pros in Acoma Pueblo - Updated Nov 2026

D & R Services
4.6(
47
)
Exterior Surfaces - SandblastingExterior Surfaces - Sandblasting - For Business

Serving Acoma Pueblo, NM and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"We were extremely happy with the whole process.  Ramon came and gave us an estimate the day we called even though he was in Gallup that morning.  Chris and Sergio arrived as scheduled to start the work.  We were concerned the pillars might be load bearing, but Sergio and Chris quickly showed that was not the case and they assured us our roof would not cave in.  Ramon, Chris, and Sergio all were very professional and made sure that we were satisfied with the work. Chris came back on day 2 and finished the job. Ramon told us from the beginning it would be a 2-day job. Chris was diligent about cleaning up each day. We recommend D&R Services and would definitely hire them again.
"
Additional Photos
stamped concrete and curb
stamped concrete and curb
stamped concrete and curb
tile

+107

Recommended by82%of homeowners
Sandblasting Services FAQs, answered by experts

The cost of sandblasting depends on the scope of the project, the surface type, labor, and equipment required. Services typically cost between $50 and $80 per hour, though most professionals charge by surface area at a rate of $1.50 to $7 per square foot. Total project costs can range from $700 to $12,500, with an average homeowner spending around $3,200 to sandblast a 1,000-square-foot surface.

Sandblasting removes old paint, rust, and grime efficiently, providing a clean surface for refinishing.

Sandblasting refers to the process of cleaning a surface using compressed air and aggregate. Soda blasting is the gentlest type of this method, but it differs from sandblasting that uses mineral or other aggregate, since sodium bicarbonate breaks apart more easily than other forms of blast media and, therefore, cannot be reused.

Sanding and pressure washing serve different purposes in deck maintenance, so one is not necessarily better than the other. Pressure washing is ideal for annual cleaning to remove dirt, grime, mold, and mildew. Sanding is a deeper restoration method used to smooth rough surfaces, remove an old finish, and prepare the wood for a new coat of stain or paint. The ideal process for refinishing a deck is to first clean it (with a power washer), then sand it, and finally apply the new stain or finish. While cleaning should be done annually, sanding and staining are typically needed only every one to three years.

You can concrete can be done when it’s wet or dry. However, it’s safer when wet, as harmful dust and chemicals are present. Sanding it when dry is faster, but you’ll agitate more dust and chemicals, meaning you’ll need to be more careful.

The Acoma Pueblo, NM homeowners’ guide to sandblasting services

From average costs to expert advice, get all the answers you need to get your job done.