Get matched with top roofers in Frenchtown, NJ

Roofers can install roof vents. Updating, upgrading, or simply replacing your roof's existing vents is common when installing a new roof. If you're looking to upgrade your ventilation system with a powered version, a local HVAC professional can also help with the task. If adding roof vents to your home is necessary while installing an addition or during other renovation work, your contractor will handle or hire out the venting work.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Architectural shingles typically last between 20 and 30 years, though most homeowners should plan on replacing them every 20 to 25 years. While some manufacturers offer warranties for 30 to 50 years, especially for extreme weather, achieving such a long lifespan is rare. The actual lifespan can be shorter in areas prone to strong winds, hailstorms, or other extreme weather. It is recommended to replace your roof before it reaches the end of its life to reduce the risk of roof failure, leaks, and costly property damage. Scheduling regular roof inspections will help you determine your roof's remaining life and identify the best timeline for replacement.

The roof pitch on a Cape Cod house is normally 8/12 or 10/12, meaning the roof rises 8 to 10 inches for every 12 inches of horizontal run. This is steeper than the now-standard 6/12 pitch, as Cape Cod homes were originally popular in northern states, where the steeper pitch helped snowfall slide readily off the roof.