Get matched with top pressure washers in Cresskill, NJ

Pressure washing pros use several factors to determine fence pressure washing costs—and one of the main factors they consider is the fence’s material. The material dictates the required PSI—which, in turn, affects the amount of labor needed for the job.

Contractors may also consider the number of gallons per minute (GPM) needed to pressure wash specific materials. GPM, which refers to the rate of water being released from a pressure washer, helps determine how long a job will take for specific fencing materials.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Before pressure washing, you can spray your deck lightly with a deck cleaning solution made of equal parts oxalic acid and water. Oxalic acid has a brightening effect that will lighten mold stains and return the deck to its original freshly-sawn look. Allow the solution to sit for about 20 minutes before pressure washing so it has time to take effect.