Get matched with top floor polishers in Omaha, NE

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.